These are the GRBL settings The x steps are different than the Y because the X has a GT-3 belt, and a different microstep, than the Y axis. The Y axis has GT-2 belts.
X microstepping is set at 1/4 (on, off, off), Y microstepping is set at 1/8 (on, off, on) and Z microstepping is set at 1/2 (off, on, off).
$0 = 10 (step pulse, usec)
$1 = 255 (step idle delay, msec)
$2 = 0 (step port invert mask:00000000)
$3 = 6 (dir port invert mask:00000110)
$4 = 0 (step enable invert, bool)
$5 = 0 (limit pins invert, bool)
$6 = 0 (probe pin invert, bool)
$10 = 3 (status report mask:00000011)
$11 = 0.020 (junction deviation, mm)
$12 = 0.002 (arc tolerance, mm)
$13 = 0 (report inches, bool)
$20 = 0 (soft limits, bool)
$21 = 0 (hard limits, bool)
$22 = 0 (homing cycle, bool)
$23 = 3 (homing dir invert mask:00000011)
$24 = 25.000 (homing feed, mm/min)
$25 = 750.000 (homing seek, mm/min)
$26 = 250 (homing debounce, msec)
$27 = 1.000 (homing pull-off, mm)
$30 = 12000. (rpm max)
$31 = 0. (rpm min)
$100 = 11.111 (x, step/mm)
$101 = 40.000 (y, step/mm)
$102 = 320.000 (z, step/mm)
$110 = 8000.000 (x max rate, mm/min)
$111 = 8000.000 (y max rate, mm/min)
$112 = 500.000 (z max rate, mm/min)
$120 = 500.000 (x accel, mm/sec^2)
$121 = 500.000 (y accel, mm/sec^2)
$122 = 50.000 (z accel, mm/sec^2)
$130 = 740.000 (x max travel, mm)
$131 = 790.000 (y max travel, mm)
$132 = 100.000 (z max travel, mm)
No comments:
Post a Comment